A Guide on How to Weld Anodized Aluminum

Many men and women assume that welding anodized aluminum is like welding any additional aluminum piping. That’s completely wrong, and there are a few of the big secrets that quite a few engineers understand. You can head over to Wonderful Engineering to learn more about anodized aluminum.

First and Second Pass Welding

To use this kind of pipe, you want to perform two passes. The initial pass is spot welded round with the filler cable being inserted. On the next pass, you weld all of the way round but minus the filler cable added this moment. The cause of that is anodized aluminum has a pretty tricky coating that’s tough to melt. The initial pass will combine the two pieces but not melt the anodized film to the weld region thoroughly. Since the layer isn’t melted rightly, the weld may seem very demanding. The next pass can melt down the anodized coating to the weld and provide the weld with a smooth look. This can be done since the anodized coating doesn’t more fully cover the weld region. Therefore, weld paint has to complete the task to defend the weld location.

Tungsten Welding

To ready the tungsten, you want a tapered ball-shaped finish. To do this, you place the tungsten on the TIG torch. Eventually, hit the high frequency and strike an arc onto a bit of clean steel or pure copper. When the arc begins, keep turning up the amperage till the tungsten starts to melt. Eventually, whenever there’s a tapered ball finish, stop the arc.

Proper welding is carried out by spot welding all of the ways around the pipe. The very first step you’ll have to do is place the TIG welder into A/C switching current. Typically there’ll be two passes necessary to weld pipe. The first is using the filler cable added and also the next it to smooth out the weld. The key to TIG welding aluminum is to maintain your amperage on the top selection, and the place welds should generally last about one moment in time every single.